Figure 90. Securing the shell to the rack with the expandable rails
Installing the system
You might need to install the system into the rack. Use the procedure in this section to perform this task.
This section also includes illustrations of the related hardware components and shows how these
components relate to each other.
To install the system into a rack, complete the following steps:
1.
If you are installing a 5790 or 7311-D11 expansion unit into the rack, slide the unit in from the back
of the shell. If you are installing a 5796 or 7314-G30 expansion unit into the rack, slide the unit in
from the front of the shell.
Important: If installing the 7314-G30 or 5796 first remove the front and back shipping covers. These
shipping covers are secured by four thumb screws each. Two screws are located on the top of the
cover and two are located on the sides of the cover.
88
Installing into a rack
A
Shell
C
Retaining screw