Table of Contents
Advertisement
Chapter 4. Removing and replacing 0551, 0553, 7014-T00, or
7014-T42 side panels
You might need to remove and replace a side panel on a rack. Use the procedure in this section to
perform this task.
The rack might have optional side panels. To remove and replace a side panel, complete the following
procedure:
1. Unlock the side panels by pressing down on both locking latches to release the latches.
Figure 106. Removing the side panel
Note: If your rack uses a ruggedized kit, you must remove the securing screw to allow each side
panel to be removed. Refer to "Releasing the side panel with a ruggedized kit" on page 114.
2. Tilt the top of the side panel slightly toward you.
3. Lift the side panel away from the ridge on the bottom of the rack.
4. Repeat this procedure for the other side panel.
Replacing a 0551, 0553, 7014-T00, or 7014-T42 side panel
You might need to replace a side panel on a rack. Use the procedure in this section to perform this task.
To replace a side panel, complete the following procedure:
1. Tilt the top of the side panel slightly toward you.
© Copyright IBM Corp. 2007, 2009
103
Hide quick links:
Advertisement
Table of Contents
