Installing The 5786, Or 7031-D24 On The Rail Assembly - IBM 7014-T00 Manual

Figure 100. Attaching the system rails
7. Using two M5 screws (D), secure the right rail to the front of the rack.
8. Moving to the back of the rack and using two M5 screws (D), secure the left rail to the back of the
rack.
9. Using two M5 screws (D), secure the right rail to the back of the rack.
10. Tighten the two screws in the middle of the left rail and the two screws in the middle of the right
rail. Refer to Figure 100.
11. Insert two nut clips at the marked location on the front-left rail.
12. Insert two nut clips at the marked locations on the front-right rail.

Installing the 5786, or 7031-D24 on the rail assembly

You might need to install the system on the rail assembly. Use the procedure in this section to perform
this task. In addition to related safety information, this section also includes illustrations of the related
hardware components and shows how these components relate to each other.
Before installing the system on the rail assembly, ensure that the stabilizers are extended and the tip plate
is attached to the bottom front of the rack to prevent the rack from falling forward when the rails are
pulled out of the rack. Refer to "Rack safety notices" on page 106.
To install the system unit on the rail assembly, follow these steps:
1. If the bezel is installed on the front of the system, remove it by pressing in on the two release buttons.
Chapter 3. Installing a system or expansion unit into a rack
99