Table of Contents
Advertisement
Chapter 10. Installing or removing a rack-mounted
system-unit latch bracket
You might need to install or remove a latch bracket. Use the procedure in this section to perform this task
These procedures describe how to install or remove the rack-mounted system-unit latch bracket. You can
perform this task yourself, or contact a service provider to perform the task for you. The service provider
might charge you for this service.
To install or remove a latch bracket, complete the following steps:
Note: The illustrations in these procedures may differ from your machine type and model.
1. Read the "Rack safety notices" on page 106.
2. Open the front rack door.
3. Push the latch bracket (A) or (B) into place on the side of the system unit.
Figure 123. Reinstalling the latch brackets
4. Secure the latch bracket with two retaining screws (C) on the side of the latch bracket.
5. Replace the front cover. See Chapter 13, "Removing and replacing covers and doors," on page 143.
6. Close the front rack door.
To remove a latch bracket, complete the following steps:
1. Remove the cover from the front of the system. See Chapter 13, "Removing and replacing covers and
doors," on page 143.
2. Place the system in the service position. See the service information for your model.
3. Remove the retaining screws (C) located on the side of the latch bracket (A) or (B).
125
© Copyright IBM Corp. 2007, 2009
Hide quick links:
Advertisement
Table of Contents
