Attaching The Cable-Management Arm To The Standard Rails - IBM 7014-T00 Manual

Figure 103. Securing the system to the back of the rack
7. Install the bezel onto the system.
Figure 104. Installing the bezel
For instructions on how to connect and configure the system when you have completed installing the
5786 or 7031-D24 into the rack, see Enclosures and expansion units.

Attaching the cable-management arm to the standard rails

You might need to attach the cable-management arm. Use the procedure in this section to perform this
task.
101
Chapter 3. Installing a system or expansion unit into a rack