Table of Contents
Advertisement
2. Hold the service access cover against the system unit, and slide it toward the front of the system.
The tabs on the service access cover slide beneath the upper chassis ledge, and the two thumbscrews
align with the screw holes at the back of the system unit.
3. Tighten the thumbscrews (B) located at the back of the cover.
Figure 135. Install the service access cover on the rack-mounted model
Removing the service access cover from a stand-alone 8203-E4A,
8204-E8A, 8261-E4S, 9407-M15, 9408-M25, or 9409-M50
Use this procedure to remove the service access cover to perform service or to gain access to internal
components.
To remove the service access cover from a stand-alone model, do the following steps:
1. Loosen the two thumbscrews (A) located at the back of the service access cover as shown in the
following figure.
2. Slide the service access cover (B) toward the back of the system. When the front of the cover clears
the front frame ledge, lift the cover off the system.
Attention: For proper cooling and airflow, install the cover before starting the system. Operating the
system without the cover for more than 30 minutes might damage the system components.
144
Installing into a rack
Hide quick links:
Advertisement
Table of Contents
