Chapter 7. Ruggedized kit
You might need to remove or replace a part in the ruggedized kit. This section includes procedures so
that you can perform these tasks.
The ruggedized kit, feature code 6080, should be ordered at the same time the rack is ordered. The
ruggedized kit brackets are installed at the manufacturer.
Note: If you are installing a rack with the ruggedized kit and need to secure the rack to the floor, refer to
Chapter 2, "Installing the rack," on page 3.
The following illustration highlights the contents of the kit and the approximate location of each bracket
and hinges in the event that you need to uninstall and reinstall a part.
Figure 114. Ruggedized kit parts
1
Rack
2
Spacer
3
Brace hinge
4
Hinge pivot studs
5
Brace latch bracket
6
Spacer
7
Screw
8
Brace thumbscrew
© Copyright IBM Corp. 2007, 2009
9
Brace hinges
10
Brace
11
Side-door securing screw mount
12
Spacer
13
Screw
14
Washer
15
Side door securing screw
113