Cashier Code And Name Programming (Submode 2) - TEC MA-1595-1 Series Owner's Manual

6. PROGRAMMING OPERATIONS
6.5

Cashier Code and Name Programming (Submode 2)

Cashier Code and Name, and Cashier Status for each cashier can be programmed here.
6.5.1 Programming
CONDITION Any time outside a sale
Mode Lock: SET
OPERATION
2 [X]
Repeat for another
cashier.
[AT/TL]
NOTES: 1. The following table shows the Cashier Codes that can be entered (the capacity is determined by
the RAM Allocation Setting).
Cashier key type
* The Cashier Code 99 for the Cashier Key Type is fixed as a code of a cashier for Training
Entries.
2. For the name of each cashier, a maximum of 12 regular-sized or 6 double-sized characters can
be entered. A combination of both types is also available.
3. Training entry status is available for every cashier.
4. When the center file is used, this programming cannot be performed on the Satellite Terminal.
5. Prior to the change of cashier status (Normal cashier
Normal cashier), daily reports and GT reports of this cashier should be taken.
|Cashier Code| [NS]
(See NOTE 1 below.)
Address 1: Cashier Name
1 [ST]
Address 2: Cashier Status
2 [ST]
(To complete this submode.)
Code entry type
[CLK] key
6.5 Cashier Code and Name Programming (Submode 2)
Character entries
Max. 12 characters
(See NOTE 2 below.)
For sequentially programming the address,
the Address number specification can be skipped.
|Cashier Status| [#]
0: Cashier for sale entries
1: Cashier for training entries ( NOTE 3 )
Standard memory
1 to 15
1 to 8, 99*
Training cashier, or Training cashier
6-11
EO1-11152
[ST]
Expansion memory
1 to 99
---