Maintenance; Joystick Unit Adjustment - Panasonic WV-CU980/G Operating Instructions Manual

Maintenance

Joystick Unit Adjustment

The method of calibrating (hereafter referred to as 'adjusting') the joystick unit (joystick, and zoom wheel controller) is explained
below.
Normally there is no need to carry out adjustment. Carry out adjustment in the following situations.
• When the camera image moves (pans or tilts) even though the joystick has not been operated (the joystick is not held and
has returned to the central position).
• When the zooming of the camera image changes even though the zoom wheel controller has not been operated (the zoom
wheel controller is not held and has returned to the central position).
Adjustment of Joystick
The joystick is adjusted as follows.
Note:
• The tilt and pan state values displayed during adjustment change according to how the joystick is moved in the up,
down, left, or right directions. Further, this may change depending on the equipment, or every time the adjustment is
made.
• During adjustment, when returning the joystick to the center, do not return it slowly, but quickly release your hand as if
to flip it. If the joystick is returned slowly, it may stop not at the center but at a position that is slightly off from the center.
Operation procedure
1 Switch ON the power supply while simultaneously
pressing +
The administrator ID input screen is displayed.
2 Enter the administrator ID using the numeric
buttons
The administrator ID that has been input is displayed on the
screen.
3 Press
The password input screen is displayed.
4 Enter the administrator password using the numeric
buttons
5 Press
When a wrong administrator ID or password has been input,
the blinking message "invalid" is displayed for a few
seconds, and then the display returns to the administrator ID
input screen. Input again the correct administrator ID and
password.
When the administrator ID and password have been input
correctly, the pan/tilt calibration settings confirmation screen
is displayed.
Joystick in the central position
The joystick tilt adjustment value is displayed in the top right
part of the screen.
When the joystick is moved in the up and down directions,
the tilt adjustment value displayed changes in the range of
-64 (joystick moved to the bottom end position) to 0 (hand
released from the joystick letting the joystick return to the
central position) to 64 (joystick moved to the top end
position).
The state in which the
joystick is moved to the top
end position
38
Joystick tilt adjustment value
(up - down direction)
Joystick pan adjustment
value (left - right direction)
The state in which the
joystick is moved to the
bottom end position