Lexus CT200H Manual page 64

64
1-1. For safe use
(1) For the CRS which do not carry the ISO/XX size class identification
(A to G), for the applicable mass group, the car manufacturer shall
indicate the vehicle specific ISOFIX child restraint system(s) rec-
ommended for each position.
Key of letters inserted in the above table:
IUF: Suitable for ISOFIX forward-facing child restraints systems of uni-
versal category approved for the use in this mass group.
X: ISOFIX position not suitable for ISOFIX child restraint systems in
this mass group and/or this size class.
1
*
: When you use a child restraint system in this position, remove the head
restraint.
The child restraint systems mentioned in the table may not be available
outside of the EU area.
Other child restraint systems different from the systems mentioned in the
table can be used, but the suitability of the systems must be carefully
checked with the child restraint system manufacturer and retailer.

When installing the child restraint system on the front passenger seat
When you have to use a child restraint system on the front passenger seat, adjust
the following:

The seatback to the most upright position

The seat cushion to the fully rearward
position

Selecting an appropriate child restraint system

Use a child restraint system appropriate for the child until the child becomes
large enough to properly wear the vehicle's seat belt.

If the child is too large for a child restraint system, sit the child on a rear seat
and use the vehicle's seat belt. (P. 40)
CT200h_OM_OM76102E_(EE)