Hardware Features - Cisco Catalyst IW6300 Series Hardware Installation Manual

Hardware Features

Model (or part number)
IW-6300H-DCW-x-K9
Note The "-x" in the model number represents a regulatory domain for a specific country.
A detailed list of components supported by each access point model is shown in the following table.
Table 2: Components of Each Access Point Model
Product/PID Power Option
IW-6300H-AC-x-K9 UPoE, PoE+, AC (100V
to 240V)
IW-6300H-DCW-x–K9 UPoE, PoE+, DC (10.8V
to 36V)
IW-6300H-DC-x-K9 UPoE, PoE+, DC (44V
to 57V)
Note
For DC SKU, if you want to output 802.3at type 2 PoE out power, DC input must >=51V. If you want to
output 802.3af (802.3at type 1) PoE out power, DC input must >=45V.
Note
When powered with PoE+ or UPoE, the PoE Out power is not available, The PoE-Out port data link can still
be active.

Hardware Features

This section describes the hardware features of the IW-6300H access point models.
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
4
Configuration
IP66 and IP67 rated, hazardous location certified, DC power version.
This model has 4 external antenna ports and contains a 2.4 GHz and 5 GHz radio with an
option to configure in centralized, Flexconnect, or mesh mode and supports 44VDC to 57
VDC power source.
Note The marked DC input range is an absolute range. Do not apply tolerances.
Antenna Ports
Four Type N
Connectors
Ethernet Ports PoE Out
Port
One 100/1000Mbps SFP 35.3W
for WAN
One 100/1000Mbps RJ45
for WAN (UPoE or PoE+
in)
Two 100/1000Mbps
RJ45 for LAN (802.3at
or 802.3af out)
Overview
I/O Ports
Four 1/2" NPT
Ports