Antenna Selection Examples - Cisco Catalyst IW6300 Series Hardware Installation Manual

Antenna Selection Examples

Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide
http://www.cisco.com/c/en/us/support/wireless/aironet-antennas-accessories/products-installation-guides-list.html
Follow all safety precautions when installing the antennas. For information on safety, see
When Installing Antennas, on page
Antenna Selection Examples
The following examples list suggested antenna and RF accessory selections for typical installation scenarios.
Use Case Antennas
Omnidirectional 2x Dual-Band
access coverage Omni-Directional
on both radios Antennas
AIR-ANT2547V-N,
AIR-ANT2547VG-N,
AIR-ANT2547V-N-HZ,
or AIR-ANT2568VG-N
Omnidirectional 2x Dual-Band
access on 2.4 Omni-Directional
GHz, backhaul on Antennas
5 GHz AIR-ANT2547V-N,
AIR-ANT2547VG-N,
AIR-ANT2547V-N-HZ,
or AIR-ANT2568VG-N
or 2x 2.4 GHz 5 dBi
Omnidirectional
Antennas
AIR-ANT2450V-N,
AIR-ANT2450VG-N,
AIR-ANT2450V-N-HZ,
or AIR-ANT2450HG-N
or 2x 2.4 GHz 8 dBi
Omnidirectional
Antennas
AIR-ANT2480V-N and
1x 5 GHz 13 dBi
Directional Antenna
AIR-ANT5114P2M-N=
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
36
18.
Coaxial Cables Lightning
Arrestors and/or
Adapters
None None
2x N(m) – N(m) cables: 2x N(m)-N(f)
Lightning Arrestor
CAB-L400-5-N-N
CGR-LA-NM-NF
CAB-L400-5-N-NS
and
CAB-L400-20-N-N
2x N(f)-N(f)
CAB-L600-30-N-N
adapter
or AIR-ACC370-NF-NF
AIR-CAB025HZ-N
Installing the Access Point
Safety Precautions
Installation Antenna
Mode
Configuration
Connect antennas directly Dual band
to ports A and B. Cap
ports C and D with
weatherproof caps.
Connect the two 2.4 GHz Single band
omnidirectional antennas
directly to ports A and B.
Mount the 5 GHz
directional antenna with
the included hardware
and connect it to ports C
and D via the adapters,
coaxial cables, and
lightning arrestors (if
required).