Cisco Catalyst IW6300 Series Hardware Installation Manual page 61

Troubleshooting
LED Message
Type
Operating
Status
Boot loader
warnings
Boot loader
errors
AP OS errors
The access point port LED signals are listed in the following table.
Color
Blinking Amber
Cycling through Green, Red,
and Amber
Rapidly cycling through Red,
Green, Amber, and Off
Blinking Red
Blinking Amber
Red
Blinking Green
Red
Blinking Red and Amber
Blinking Red and Off
Red
Cycling through Red, Green,
Amber, and Off
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
Meaning
A software upgrade is in progress
Discovery/join process is in progress
This status indicates that the Access Point location command
has been invoked.
This status indicates that an Ethernet link is not operational
Configuration recovery is in progress (the Reset button has
been pushed for 2-3 seconds)
There is an Ethernet failure or an image recovery (the Reset
button has been pushed for 20-30 seconds)
An image recovery is in progress (the Reset button has been
released)
There has been a DRAM memory test failure
There has been a FLASH file system failure
This sequence may indicate any of the following:
• Environment variable failure
• Bad MAC address
• Ethernet failure during image recovery
• Boot environment failure
• No Cisco image file
• Boot failure
There has been a software failure; a disconnect then reconnect
of the unit power may resolve the issue
This is a general warning of insufficient inline power
Monitoring the Access Point LEDs
53