Connecting Dc Power To Iw-6300H-Dcw-X-K9 - Cisco Catalyst IW6300 Series Hardware Installation Manual

Connecting DC Power to IW-6300H-DCW-x-K9

Step 6
Insert each hot wire into the AC entry terminal block.
Step 7 Use a Phillips screwdriver to tighten the terminal block set screws to secure the wires in the terminal block.
Step 8
Verify that no bare wire is exposed. If wire is exposed, remove it from the terminal block, adjust the length,
and reinstall.
Step 9 Check your work.
Step 10
Close the access point cover. See
Connecting DC Power to IW-6300H-DCW-x-K9
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:10 A. Statement 1005
Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022
Warning To reduce risk of electric shock, connect the unit only to DC power source that complies with the Safety
Extra-Low Voltage (SELV) requirements in IEC 60950 based safety standards or ES1 requirements in IEC
62368 based safety standards. Statement 1033
To route and connect the power cable to the IW-6300H-DCW-x–K9 model, follow these steps:
Procedure
Step 1
Open the access point cover. See
Step 2 Ensure a 6 AWG ground wire is connected to the access point (see
Step 3
Route the power cable through the 1/2 NPT port.
Step 4 Use a wire stripper tool to remove the insulation from each wire. Remove only enough wire to provide a solid
connection in the terminal block. The hot wires should have no bare wire exposed after the connection is
made.
Step 5 Insert the ground wire into the internal ground.
Step 6
Insert each hot wire into the terminal block.
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
44
Closing the Access Cover, on page 34
Opening the Access Cover, on page 33
Installing the Access Point
for details.
for instructions.
Grounding the Access Point , on page 38).