Cisco Catalyst IW6300 Series Hardware Installation Manual page 32

Mounting the Access Point on a Wall
Materials Required
Electric drill and standard screwdriver
#6-AWG ground wire
Shielded outdoor-rated Ethernet (CAT5e or better) cable
Grounding block
Grounding rod
13-mm box-end wrench or socket set
Caution The mounting surface, attaching screws, and optional wall anchors must be able to support a 50-lb(22.7 kg)
static weight.
The mounting bracket can be used as a template to mark the screw hole locations. To mount the access point
on a vertical wall, follow these instructions:
Procedure
Step 1 Use the mounting bracket as a template to mark four screw hole locations on your mounting surface. You can
optionally use the individual mounting holes or the mounting slots.
Figure 11: Mounting Bracket Dimension
Cisco Catalyst IW6300 Heavy Duty Series Access Point Hardware Installation Guide
24
Installing the Access Point
In
Kit
No
No
No
No
No
No