Step 9: Install The Front Doors On The Ptx3000 - Juniper PTX3000 Quick Start Manual

Step 9: Install the Front Doors on the PTX3000

Front doors are installed over the card cage that contains the components in the chassis. Each PTX3000
is shipped with two front doors, one door for each card cage. Captive thumbscrews secure the door to
the chassis.
To install an upper or lower card front door on a PTX3000 (see
1. Gather the following tools:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 2
2. Attach an ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
CAUTION:
connect the wrist strap to an approved site ESD point. See the instructions for your
site.
3. Place the door over the appropriate card cage in the chassis.
4. Using your fingers, loosely tighten the thumbscrews on each side of the door.
5. Tighten the screws completely by using a number 2 Phillips (+) screwdriver to secure the door to the
chassis.
NOTE: If you must return the chassis to Juniper Networks for any reason, you must remove
the front doors from the chassis. See Packing the PTX3000 for Shipment in the
Transport Router Hardware
During the initial installation before the chassis is grounded, you must
Guide.
Figure 27 on page 37):
PTX3000 Packet
36