Step 4: Install The Ptx3000 - Juniper PTX3000 Quick Start Manual

Step 4: Install the PTX3000

CAUTION:
Verify that a mechanical lift is available for the installation.
Have a qualified technician verify that the rack is strong enough to support the chassis
weight and is adequately supported at the installation site.
Ensure that the rack is in its permanent location and is secured to the building.
Ensure that the installation site allows adequate clearance for both airflow and
maintenance.
NOTE: A mounting shelf is not required to install the PTX3000.
To install the PTX3000 by using a lift (see
1. Load the PTX3000 onto the lift, making sure the PTX3000 rests securely on the mechanical lift.
CAUTION:
flanges. Use these handles only to help position the PTX3000.
2. Using the lift, position the PTX3000 in front of the rack. Lift the chassis slightly above the position you
plan to install it, and position it as close as possible to the rack.
3. With two people in front, push the front-mounting flanges to slide the PTX3000 into the rack until the
front-mounting flanges contact the rack rails. The front-mounting flanges of the chassis align with the
holes in the rack rails.
4. Install a mounting screw into each of the mounting holes aligned with the rack, starting from the bottom
(see Table 3 on page
Visually inspect the alignment of the PTX3000. If the PTX3000 is installed properly in the rack, all the
mounting screws on one side of the rack should be aligned with the mounting screws on the opposite
side, and the PTX3000 should be level.
Before installing the PTX3000 router:
Figure 4 on page 11
Do not lift the PTX3000 by using the handles on the front-mounting
10). Use an appropriate screwdriver to tighten all the screws completely.
and Figure 5 on page 12):
9