Safety Warnings - Juniper PTX3000 Quick Start Manual

Safety Warnings

WARNING:
summary of safety warnings. For a complete list of warnings for the PTX3000, including
translations, see the
https://www.juniper.net/documentation/.
WARNING:
connection to intrabuilding or unexposed wiring or cabling only. The intrabuilding ports
of the equipment or subassembly MUST NOT be metallically connected to interfaces
that connect to the Outside Plant (OSP) or its wiring. These interfaces are designed for
use as intrabuilding interfaces only (Type 2 or Type 4 ports as described in GR-1089) and
require isolation from the exposed OSP cabling. The addition of Primary Protectors is
not sufficient protection in order to connect these interfaces metallically to OSP wiring.
WARNING:
connections must be removed completely to remove power from the unit completely.
Attention Cette unité est équipée de plusieurs raccordements d'alimentation. Pour
supprimer tout courant électrique de l'unité, tous les cordons d'alimentation doivent être
débranchés.
CAUTION:
to an ESD point, and place the other end of the strap around your bare wrist. Failure to
use an ESD strap could result in damage to the router.
CAUTION:
Only trained and qualified personnel must install or replace the PTX3000.
Perform only the procedures described in this Quick Start or in the
Hardware Guide. Other services must be performed by authorized service personnel only.
See installation instructions before connecting the PTX3000. This is a
PTX3000 Packet Transport Router Hardware Guide
The intrabuilding ports of the equipment or subassembly are suitable for
The network device has more than one power supply connection. All
Before removing or installing components of a PTX3000, attach an ESD strap
Use an external surge protective device (SPD) at the AC input of the router.
at
PTX3000 Packet Transport Router
42