Drive System Maintenance; Removing And Installing The Wheels; Replacing The Drive Belt - Toro 58620 Operator's Manual

Drive System
Maintenance
Removing and Installing
the Wheels
Service Interval: Every 25 hours—Lubricate the
jackshaft assembly.
Remove and install the wheels as shown.
Figure 18
1. Axle nut
2. Wheel
g337013
3. Spacer
4. Lockwasher

Replacing the Drive Belt

1. Remove the 2 fasteners securing the rear of the
shield to the mower housing.
1. Rear fastener (2)
2. Front fastener (4)
3. Shield
2. Remove the 4 fasteners securing the front of the
shield and mower head to the mower housing.
3. Raise the front of the mower housing, loosen the
mounting bolt on the drive pulley, and remove
the "V" pulley from the idler bracket.
Important:
Do not bend the belt guides.
16
Figure 19
4. Mower head
5. Drive belt
g393641