Table of Contents
Advertisement
Understanding Electrical Hazards
Do not use power extension cords with the docking station unless properly rated.
l
Never access the AMR's interior while it is attached to a charger.
l
Immediately disconnect the battery after you open the battery compartment door.
l
Avoid shorting the battery terminals.
Do not use any charger not supplied by Omron.
l
If the AMR comes into contact with any liquid:
l
o
o
o
o
Understanding Burn Hazards
Understanding Magnetic Field Hazards
Docking Funnel Magnets
!
8.4 Lifting the LD-250 Safely
If you need to lift the LD-250 for any reason, take care to lift from safe lifting points and secure
it with safety straps to prevent falling. An appropriate number of persons is required to manu-
ally lift an AMR, depending on the base platform weight and the additional weight of its pay-
load. Omron recommends using a mechanical lift when possible. See: Component Weight on
page 192.
20472-000 Rev B
WARNING: ELECTROCUTION RISK
The docking station has AC power inside. Docking station covers are not inter-
locked.
Power off the AMR.
Clean off as much liquid as is possible.
Allow the AMR to air dry thoroughly before restoring power.
Contact your local Omron Support if you suspect that liquid has penetrated the
skins or contaminated the AMR's interior.
CAUTION: BURN RISK
Parts of the drive train can get hot during operation. Allow the LD-250 to cool
before servicing.
WARNING: MAGNETIC FIELD - MEDICAL IMPLANT RISK
Magnetic fields can be hazardous to medical implant wearers. Medical
Implant wearers should stay at least 30 cm (12 inches) away from the under-
side of the LD-250, which is exposed during certain maintenance procedures
when the LD-250 is on a raised work surface.
LD-250 Platform User's Guide
Chapter 8: Maintenance
145
Advertisement
Table of Contents
