Floppy Disk; Language - Bosch BEA 150 Repair Instructions

11.3

Floppy disk

This menu serves to test the floppy disk drive on the BEA.
i To test the floppy disk drive the BEA test software must remain
in the drive!
1. Use key F1 or F2 to select the Floppy disk menu.
2. Start the test using the F5 key.
The following picture is displayed.
BEA Test Vers. 1.0
Floppy
Floppy ( /uh )
Test

Language

Exit Program
Select with F1 / UP or F2 / DOWN
Accept with F5 / ENTER / >>
Abort with ESC
3. Confirm by pressing the F5 key.
A read test from the disk then follows.
4. The following warning message appears once the read test
ends.
BEA Test Vers. 1.0
Floppy / Test
Warning!
If you continue, the structural
integritiy may Possibly be de-
stroeyd.
Continue with F5 / >>
Abort with ESC
90
5.
6.
+
+
7.
11.4
This menu can be used to select the BEA test software language.
1.
2.
3.
4.
Confirm by pressing the F5 key.
A write test on the disk then follows.
The following picture is displayed if the write test is passed.
BEA Test Vers. 1.0
Floppy / Test
Read test /uh . . .
Test Passed.
Testing file structure /uh . . .
Test Passed.
Write test /uh . . .
Test Passed.
All tests Passed, no error.
Elapsed time: 5 min.
Acknowledge with F5 / Enter / >>
In the event of a fault the floppy disk has to be replaced (see
chapter 10.22).
Confirm by pressing the key F5 / Enter / >>.
Language 11.4 Language
Use F1 or F2 key to select the Language menu.
Open the menu using the F5 key.
The following picture is displayed.
BEA Test Vers. 1.0
Language
Language
Deutsch
English
Exit Program
Select with F1 / UP or F2 / DOWN
Accept with F5 / ENTER / >>
Abort with ESC
Use F1 or F2 key to select the language you require.
Confirm by pressing the F5 key.
The pre-selected language is then set.
15 sec.
+
+