Set Indoor Station As End Device; Snap-On The Upper Cover - TCS IVX9001-0140 Product Information

Connect the lines
 Minimise the length of the lines above
the lower cover to place the lines with-
out any problems and to prevent
clamping the lines when snapping-on
the upper cover.
 Connect the lines according to the
labeling within the lower cover to the
connection terminal. (The terminal can
be removed from the guide rail.)
 Run the lines along the dedicated site.
 Ensure that there is no uninsulated or
not connected wire (e.g. cable shield)
in the space for cabling as this could
cause a short-circuit.

Set indoor station as end device

The indoor station is positioned at the
end of a strand or is the only device in
the strand:
 Push the slide switch S1 (on the print-
ed circuit board in the upper cover) to
the right. Thus, the matching resistor is
"placed".
(scope of delivery: "not placed")

Snap-on the upper cover

 Set the upper cover on both latches of
the lower cover (1).
 Snap-in the upper cover with slight
pressure (2).
8
S1