Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual page 263

Figure 174: Connecting the power cable and PCIe SSD cable routing
Ê Connect the power cable C5 to connector "PWR4" on the system board.(1).
Ê Install the two Retimer controllers, see chapter
two Retimer controllers" on page
Ê Run the PCIe SSD cables as shown.
Ê Run the PCIe SSD cables through the cable guide (2).
Ê If applicable, connect the OOB cable, see section
cable" on page
Ê If applicable, install the fan bridge, see section
page 90
Ê Install the system air duct, see section
page 68.
TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
488.
Upgrade and Maintenance Manual
"Example: Configuration with
316.
"Replacing the OOB
"Handling fan bridges" on
"Installing the system air duct" on
263