Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual page 206

Hard disk drive (HDD) / solid state drive (SSD)
Figure 125: Installing the SAS expander board holder (D)
Ê Connect the two SAS cables:
1 SAS cable C10 from SAS expander board connector X1 to the
connector MLC1 on the SAS controller
2 SAS cable C10 from SAS expander board connector X2 to the
connector MLC2 on the SAS controller
Ê If applicable, connect the OOB cable, see section
cable" on page
Ê Pull down the SAS expander board holder carefully.
Fasten the SAS expander board holder with the screw (see figure 115).
Ê
I
For the cable plan see chapter
206
488.
Upgrade and Maintenance Manual
"Replacing the OOB
"Appendix B" on page 517.
TX2550 M4