Step 4: Installing Anti-Tip Device - Thermador Professional Series Installation Instructions Manual

Step 4: installing Anti-Tip Device
For al[ 30" and 36" ranges, an anti-tip device must be installed as per these
instructions.
_, WARNING
RANGE TiPPiNG
Aim ranges can tip and injury can result. To
prevent accidental tipping of the range,
attach it to the floor, wall or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appliance
is not installed in accordance with these
instructions.
[f the range is pulled away from the wall
for cleaning, service or any other reason,
ensure that the Anti-Tip Device is prop-
er[y reengaged when the range is pushed
back against the wall. in the event of
abnorma[ usage (such as a person stand=
ing, sitting, or leaning on an open door),
failure to take this precaution can result
in tipping of the range. Persona[ injury
might result from spilled hot liquids or
from the range itself.
_, WARNING
o ALL RANGES CAN
TiP
o iNJURY TO PER-
SONS COULD
RESULT
o iNSTALL ANTi-TiP
PACKED
WiTH RANGE
o SEE iNSTALLATiON
iNSTRUCTiONS
_, WARNtNG
ELECTRICAL SHOCK HAZARD
• Use extreme caution when drilling holes
into the wall or floor. There may be
concealed electrical wires located
behind the wall or under the floor.
. [dentify the electrical circuits that could
be affected by the installation of the
Anti-Tip Device, then turn off power to
these circuits.
. Failure to follow these instructions may
result in electrical shock or other per-
sona[ injury.
CAUTION
PROPERTY DAMAGE
• Contact a qualified installer or contractor
to determine the proper method for drill-
ing holes through the wall or floor material
(such as ceramic the, hardwood, etc.)
. Do not slide the range across an unpro-
tected floor.
Failure to follow these instructions may
result in damage to wall or floor cover-
ings.
Tools Needed for installation of Anti-Tip Device:
=Screwdriver, Phillips =Hammer
=Drill, electric or hand =Pencil or other marker
=Measuring tape or ruler
=1/8" drill bit (wood or metal wail or floor)
=3/16" carbide=tipped masonry drill bit (concrete or concrete block wail or floor)
=3/16" anchors, drywall or concrete, 2 each (not required if mounting bracket is being attached to solid wood or
metal)
11