10. Maintenance
Image 10-9
Rear view : plate removed
refer to the lamp replacement procedure in the service manual or the lamp installation manual.
10.3 Projector removal
Introduction
In case of projector servicing, the projector has to be removed from the assembly.
W
ARNING
How to remove the projector ?
1. Loosen the 8 screws and remove the rear plate, image 10-8
2. Loosen and remove the 3 feet bolts
Warning: For the projector mounted upside down : if the projector is not sustained it will fall down ! ...
3. Take the projector out of the frame
W
ARNING
52
:
Following operations must be done by at least 2 persons.
:
This must be done by at least 2 persons !
R5976989 BARCO VR WORKROOM 22/09/2006