Positioning - Barco VRWF-3200 System Installation Manual

Image 5-11
The assembly is factory pre-aligned for above setup, some fine adjustment may however be necessary. In this
case, see the Fine adjustment section.
5.3.1

Positioning

When ?
This is only necessary in case of a non fixed installation or if the mounting holes have not yet been determined (and drilled) in the
floor.
How to position the assembly ?
1. Turn and position the assembly so as to obtain parallel image top and bottom edges. (image 5-12)
2. Position the assembly so as to center the image on the screen (image 5-13)
R5976989 BARCO VR WORKROOM 22/09/2006
842
836 2561
3477
5. Mechanical Installation
23