Table of Contents
Advertisement
9. Getting started
How to start up the VR Workroom using the keyboard (recommended method) ?
1. Press the Esc button on the keyboard (connected to the master)
Note that the startup happens in 2 steps : the Master projector starts up and starts up the Slave (via RS232).
During the boot sequence the Slave projector's desktop control is taken over by the Master projector.
How to start up the VR Workroom using the RCU ?
1. Press the standby button on the RCU (image 9-4)
The 2 projectors will start up
M EN
U
PA
U SE
9
Image 9-4
Same start sequence as above
C
AUTION
sent by the Remote Control are received by the Master only. Never change the address of the Remote.
Always direct the RCU towards the Master (transparent bottom part of the system)
Image 9-5
Logging on
1. Log on using your password or, in case of a first startup, by using the default Barco password : username = administrator,
password = Barco
9.2
Projector shutdown
Shutdown
It is always recommended to put only the projectors off. This way the servers remain operational guaranteeing quick system readi-
ness at next startup.
44
B A C K
EN
T ER
PI P
L O G O
D I G I
Z O O M
0
PH
A SE
:
The Remote Control Unit (RCU) is set up to control the Master projector only ! The commands
RCU
R5976989 BARCO VR WORKROOM 22/09/2006
Advertisement
Chapters
Table of Contents
