Parameters In Syslog Messages - Siemens SCALANCE W1780 Configuration Manual

Appendix E
E.2 Parameters in Syslog messages
E.2

Parameters in Syslog messages

The Syslog messages can contain the following parameters:
Parameter
ip address
src port
dest port
client mac
dest mac
src mac
protocol
group
user name
action user name
role
time minute
timeout
time second
failed login count
max sessions
vap
status reason
wlan interface
ssid
356
Description
IPv4 or IPv6 address
Port that is shown as decimal number.
Format: %d
MAC address
Format: %02x:%02x:%02x;%02x:%02x:%02x
Name of the service that has generated this event
or of the Layer 4 protocol used.
Format: %s
String that identifies the group based on its name
Format: %s
String that identifies the authenticated user based
on his/her name
without spaces
Format: %s
Identifies the user based on his/her name This is
not the authenticated user.
Format: %s
Symbolic name for the group role
Format: %s
Number of minutes
Format: %d
Number of seconds
Format: %d
Number of failed logins
Format: %d
Number of sessions
Format: %d
Symbolic name of the virtual access point interface
Format: (%s) or (%s %s)
Additional status information as legible string. It
can contain multiple words. The string must start
with " and end with " so that it can be analyzed.
Symbolic name of the WLAN interface
Format: %s
SSID in ASCII representation
any number of spaces
Format: %s
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Possible values or example
IP address according to
RFC1035 or RFC4291 Sec‐
tion 2.2
0 ... 65535
00:0C:29:2F:09:B3
Possible entries of:
UDP | TCP | WBM | Telnet |
SSH | Console | TFTP
| SFTP
it-service
maier
Peter.Maier
Administrator
44
44
10
10
VAP1.1
(Invalid group cipher) (Un‐
known peer)
WLAN1
MyWLAN
Configuration Manual, 11/2019, C79000-G8976-C485-03