Messages In The Event Log - Siemens SCALANCE W1780 Configuration Manual

Appendix D
D.1

Messages in the event log

Messages during system startup (general)
Alarm
Warm start performed, Ver: V02.00.00 - event/
status summary after startup
Power supply:
● L1 is connected
● L2 is not connected
No line is monitored
MSTP disabled
MSTP enabled
No Fault states pending after startup
Status of the power supply
You enable or disable the "Power Change" event in "System > Events".
Alarm
Power up on line 1 / 2 / PoE.
Power down on line 1 / 2 / PoE.
Status of the Ethernet interface
You enable or disable the "Link Change" event in "System > Events".
Alarm
Link up on P1.
Link down on P1.
Status of the WLAN interface (in access point mode only)
Messages
Link down up VAP X.Y.
Link down on VAP X.Y.
WDS Y at WLAN X is up.
WDS Y at WLAN X is down.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
Description
Type of startup and the loaded firmware version.
Status of the power supplies line 1 and line 2.
Information about monitoring the power supply from the signaling system.
Information on the status of the Spanning Tree protocol.
Fault state following system start.
Description
Power supply exists on line 1, line 2 or PoE..
Power supply interrupted on line 1, line 2 or PoE.
Description
A connection exists on the Ethernet interface.
No connection exists on the Ethernet interface.
The VAP interface Y on the WLAN interface X is enabled.
The VAP interface Y on the WLAN interface X is disabled.
A link exists on the WDS interface Y of WLAN interface X.
No link exists on the WDS interface Y of WLAN interface X.
D
349