Cli\System\Snmp\Trap Menu Command; Cli\System\Syslog Menu Command - Siemens SCALANCE W786-xPRO Operating Instructions Manual

edit <index> <group name>
[NONE|MD5|SHA]
[authentication pw]
[encryption pw]
delete <Index>
clearall
See also
SNMP Config menu command (Page 103)
5.7.2.10

CLI\SYSTEM\SNMP\TRAP menu command

Enabling SNMP traps, specifying trap recipients
With the commands of this menu, you configure SNMP traps.
CLI\SYSTEM\SNMP\TRAP>
Command
traps [E|D]
settrap <entry>
<IP address>
<E|D>
clearall
See also
SNMP Config menu command (Page 103)
5.7.2.11

CLI\SYSTEM\SYSLOG menu command

Time-of-day synchronization in the network
With the commands in this menu, you specify the SYSLOG server and the log entries.
SCALANCE W786-xPRO
Operating Instructions, Release 08/2007, C79000-G8976-C221-02
Changes the group
assignment, the
authentication algorithm,
and the encryption
password of the SNMPv3
user.
Deletes an SNMPv3 user
from the list at the point
identified by the index.
Deletes all SNMPv3 users.
Description
Enables / disables SNMP
traps.
Specifies the IP address of the
trap recipient "entry" ("entry"
between 1 and 10) and
enables / disables the sending
of traps to this recipient.
Deletes all entries from the
trap configuration table.
Configuration / project engineering
5.7 Configuration with the Command Line Interface
Comment
ᅳ ✔ ✔
ᅳ ✔ ✔
ᅳ ✔ ✔
Comment
IWLAN/ W744 W746
PB LINK
Traps are then enabled, if SNMP v1, v2c is also enabled.
✔ ✔ ✔
✔ ✔ ✔
✔ ✔ ✔
✔ ✔ ✔
✔ ✔ ✔
✔ ✔ ✔
W747 W78x W78x
RR
✔ ✔ ✔
✔ ✔ ✔
✔ ᅳ ᅳ
183