Attaching The Strap - Brady BMP 61 User Manual

Attaching the Strap

The strap can be attached to the back of the printer to provide a secure grip when holding the printer in
your hand or hanging it on a hook.
1. First, remove the label supply. Then, with
the scratch (burr) fastener facing down,
thread the double D-ring hand strap through
the loop on the lower portion of the back of
the printer.
3. Pull the loose end of the strap under and
through both D-rings.
5. Weave the loose end of the strap back over
the lower ring, then under and through the
top ring.
®
BMP 61 User's Manual
2. Still on the back of the printer, feed the strap
under the loop at the top of the printer,
directly into the printer.
Then turn the printer over and from the
inside, feed the strap out through the top of
the loop.
4. Separate the two D-rings so there is enough
space for the strap to pass between them.
Double
D-Rings
6. Pull the loose end of the strap until it feels
tight, then press the scratch (burr) fastener
against the strap so it lays flat.
Introduction
Attaching the Strap
IN
OUT
17