Accessories - Rangemaster Nexus 110 Dual Fuel User's Manual & Installation Instructions

Accessories

Glide-out Oven Shelves
The left-hand oven is supplied with 2 glide-out oven shelves.
To fit the glide-out shelf, hook the front of the shelf onto the
runners as shown (Fig. 3.3). The rear of the shelf should rest
on the runners, in front of the rear stop (Fig. 3.3).
The glide-out shelf and runners can be easily removed or
repositioned.
To remove the glide-out shelf
Raise the rear of the shelf, so that it clears the rear stops. Then
unhook from the front locating bracket.
To remove the glide-out runners
Twist to unclip the base of the runners from the shelf
supports. Then unhook the runner from the top rung of the
shelf support and remove (Fig. 3.4).
To refit the glide-out runners
Hook the rear of the runner over the top rung of a pair of shelf
supports. Then hook the front of the runner onto the same
rung. Push to clip under the bottom rung (Fig. 3.5).
Ensure that the shelf runners are fitted in the same position
on each side (Fig. 3.6).
The front of the shelf runners can be identified by the bracket
(Fig. 3.3).
DO NOT put the glide-out shelf runners in a
n
dishwasher.
Steam cavity Shelves
The steam cavity shelves (Fig. 3.7) are retained when pulled
forward but can be easily removed and refitted.
Pull the shelf forward until the back of the shelf is stopped by
the shelf stop bumps in the oven sides (Fig. 3.8).
Lift up the front of the shelf so the back of the shelf will pass
under the shelf stop and then pull the shelf forward
(Fig. 3.9).
To refit the shelf, line up the shelf with a groove in the oven
ladders and push the shelf back until the ends hit the shelf
stop. Lift up the front so the shelf ends clear the shelf stops,
and then lower the front so that the shelf is level and push it
fully back (Fig. 3.10).
Front
bracket
FRONT
Fig. 3.4
Fig. 3.8
ArtNo.320-0013 Removing the shelf 3
17
Rear stop
2
1
Front
Fig. 3.3
Fig. 3.5
1
2
Fig. 3.6
Fig. 3.7
Fig. 3.9
Fig. 3.10