Steam Cavity - Rangemaster Nexus 110 Dual Fuel User's Manual & Installation Instructions

Fig. 5.12
Fig. 5.13
Fig. 5.14

Steam Cavity

Before cleaning your oven or performing
n
maintenance, please switch off the power supply.
In order to prolong the service life of steam cavity,
please note the following points:
The enameled or stainless steel parts should be washed
with lukewarm water without using any abrasive powders or
corrosive substances which could scratch, stain and damage
the oven. After cleaning, it is advisable to rinse thoroughly
and dry.
The inside of the oven should preferably be cleaned
immediately after use, when it is still warm, with hot water
and soap. After cleaning, it is advisable to rinse thoroughly
and dry.
The base of the steam cavity will remain HOT after
n
use. Take extra care when cleaning.
To remove the ladders unscrew the retaining screws
(Fig. 5.12).
Avoid using abrasive detergents (for example cleaning
powders, etc) and abrasive sponges for dishes or acids
(such as lime scale remover, etc) as these could damage the
enamel. If the grease spots and dirt are particularly tough to
remove, use a special product for oven cleaning, following
the instructions provided on the packet.
Never use a steam cleaner for cleaning inside the oven.
Use a descale product which is suitable for descaling a coffee
machine. Do not use a foam cleaner.
Avoid using grinding sand mold cleaner, such as wash mat,
steel wire ball, etc, as this may damage the surface.
Important: please do not clean the water tank in the
n
dishwasher.
Descale (manual)
Note: Once the descale cycle is started it cannot be stopped
and has to complete (approx. 30 minutes).
Touch and hold the 'Standby' button to switch the display on,
use the [ + ] or [ - ] buttons to select the descale function [
Tap the 'Start / Pause' button to begin the descale cycle.
Fill the water tank with 0.5 litres of descaling solution
(Fig. 5.13). Once the water tank is replaced the cycle will
begin
The cycle will take 30 minutes to complete, at the end of
which, you will be asked to change the water (Fig. 5.14)
twice, whilst it is pumped though the boiler to remove the
descaler solution.
Once completed the unit will beep and the display will show
[ End ].
Descale (automatic)
After 48 hours of boiler use your steam oven will request
a descale. Follow the instructions detailed above under
"Descale (manual)".
30
].