Table of Contents
Advertisement
WIRE RACKS
•
Assemble the wire racks to the oven
walls using the 2 screws (Fig.4.1).
•
Slide into the guides, the shelf and the
tray (fig. 4.2).
The shelf must be fitted so that the
safety catch, which stops it sliding out,
faces the inside of the oven.
•
To dismantle, operate in reverse or-
der.
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a mild
detergent solution and warm water.
Suitable proprietary chemical cleaners may
be used after first consulting with the ma-
nufacturers recommendations and testing
a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity sur-
face.
NOTE: The manufacturers of this applian-
ce will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay spe-
cial attention no to touch the hot hea-
ting elements inside the oven cavity.
REPLACING THE OVEN LIGHT
WARNING: Ensure the appliance is
switched off before replacing the lamp to
avoid the possibility of electric shock.
•
Let the oven cavity and the heating
elements to cool down.
•
Switch off the electrical supply.
•
Unscrew the protective cover "C" (fig.
4.3).
•
Unscrew and replace the bulb "B" with
a new one suitable for high temperatu-
res (300°C) having the following speci-
fications: 230V, E14 and same power
(check watt power as stamped in the
bulb itself) of the replaced bulb.
•
Refit the protective cover "C".
NOTE: Oven bulb replacement is not cove-
red by your guarantee.
Fig. 4.1
Fig. 4.2
B C
Fig. 4.3
17
Advertisement
Table of Contents
