Related Manuals for DeLonghi DE608M
Summary of Contents for DeLonghi DE608M
- Page 1 C OO KIN G INSTALLATION and SERVICE INSTRUCTIONS USE and CARE INSTRUCTIONS D E6 08 M D E6 08 AR TB M U LT I F UN C TIO N BUILT-IN OVE NS distributed by DeLonghi Australia Pty Ltd DeLonghi New Zealand Ltd...
-
Page 2: Product Label
Dear Customer, Thank you for having purchased and given your preferen- ce to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the fea- tures offered by your appliance. -
Page 3: First Use Of The Oven
Important: This appliance is designed and manufactured solely for the coo- king of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a com- mercial environment. The appliance guarantee will be void if the appliance is used within a non domestic environment i.e. -
Page 4: Important Precautions And Recommendations
IMPORTANT PRECAUTIONS AND RECOMMENDATIONS After having unpacked the appliance, check to ensure that it is not damaged and that the oven door closes correctly. In case of doubt, do not use it and consult your supplier or a professionally qualified technician. - Page 5 However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury. ■ Do not line the oven walls with aluminium foil. Do not place ba- king trays or the drip tray on the base of the oven chamber.
-
Page 6: Installation
■ Do not seal the oven into the cabinetry with silicone or glue; this makes future servicing difficult. Delonghi will not cover the costs of removing the oven, or of damage caused by this removal. ■ The walls surrounding the oven must be made of heat-resistant material. - Page 7 Figure 1a Figure 1b Figure 2a Figure 2b 50 mm...
-
Page 8: Fixing The Oven
FIXING THE OVEN Introduce the oven into the furniture opening and fix it with 4 screws (not supplied) as figure 3. It is essential that the oven rests on a surface which will support its weight, as the screw fixing is only complementary. Note It is essential that when installing your oven adequate air circulation is allowed for within the installation. - Page 9 Figure 4 Oven Door OVEN DOOR Lower Trim LOWER TRIM Air Flow AIR FLOW IMPORTANT: Please take extra care not to damage the lower trim of the oven. Ensure the oven sits on wooden blocks or similar supports when it is removed from the carton as shown in above diagram.
-
Page 10: Electrical Requirements
ELECTRICAL REQUIREMENTS ■ The appliance must be connected to the mains checking that the voltage correspon- ds to the value given in the rating plate and that the electrical cable sections can withstand the load specified on the plate. ■ A suitable isolating switch providing full disconnection from the mains power supply shall be incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. -
Page 11: Replacing The Power Supply Cable
REPLACING THE POWER SUPPLY CABLE Important! This appliance must be connected to the electricity supply only by an authorised person. To connect the supply cable: ■ Unhook the terminal board cover by inserting a screwdriver into the two hooks “A” (fig. 5). ■... -
Page 12: Electric Diagram
ELECTRIC DIAGRAM Figure 8... - Page 13 ELECTRIC DIAGRAM KEY Oven switch Oven thermostat LF/LF1 Oven lamps Oven programmer Cooling fan motor Oven fan motor Oven top element Oven grill element Oven bottom element Oven circular element Thermal overload Cooling fan motor thermal overload Thermostat pilot lamp Line pilot lamp Terminal block Earth connection...
-
Page 14: Using The Oven For The First Time
USE AND CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be considered as inappropriate and therefore dangerous. ■... -
Page 15: Grease Filter
GREASE FILTER Figure 10 ■ A special screen is provided at the back of the oven to catch grease par- ticles, mainly when meat is being roa- sted (fig. 10). ■ Clean the filter after any cooking! The grease filter can be removed for cleaning and should be washed regu- larly in hot soapy water (fig. -
Page 16: Control Panel
CONTROL PANEL Figure 13a Mod. DE608M Figure 13a Mod. DE608ARTB Controls description Oven temperature control knob Digital electronic programmer Function selector control knob Pilot lamps Oven temperature indicator light Power on indicator light Please note: Your appliance has been fitted with a cooling fan to achieve optimum efficiency of the con- trols and to ensure lower surface temperatures are maintained. - Page 17 USING THE PRESS-AND-TURN CONTROL KNOBS (only for model DE608M) The control knobs are flush-mounted in the control panel. Use them as follows: Press lightly on the knob (figure 14-A); The knob will extend outwards as illustrated in figure 14-B. Turn the knob to the required position (figure 14-C).
-
Page 18: Cooking With Multifunction Oven
COOKING WITH MULTIFUNCTION OVEN OPERATING PRINCIPLES Attention: The oven door becomes Heating and cooking in the MULTIFUN- very hot during operation. CTION oven are obtained in the following Keep children away. ways: a. by normal convection GENERAL FEATURES The heat is produced by the upper and lower heating elements. -
Page 19: Thermostat Knob
Mod. TEMPERATURE DE608ARTB DE608ARTB Mod. Mod. DE608M DE608M Figure 15 Figure 16 THERMOSTAT KNOB To turn on the heating elements of the oven, set function selector knob to the required po- sition and the thermostat knob to the desired temperature. - Page 20 ) GRILLING The infra-red heating element is switched on. The heat is diffused by radiation. Use with the oven door closed and the thermostat knob must be regulated between 50°C and 225°C maximum. For correct use see chapter “USE OF THE GRILL”. Always grill with the oven door closed.
-
Page 21: Cooking Advice
MAINTAINING TEMPERATURE AFTER COOKING OR SLOWLY HEATING FOODS The upper element and the circular element connected in series, are switched on; also the fan is on. The heat is diffused by forced convection with the most heat being produced by the upper ele- ment. -
Page 22: Use Of The Grill
SIMULTANEOUS COOKING OF DIFFERENT FOODS The MULTIFUNCTION oven set on position ) or ) gives simultaneous heterogeneous cooking of different foods. Different foods such as fish, cake and meat can be cooked together without mixing the smells and flavours. This is possible since the fats and vapors are oxidized while passing through the electrical element and therefore are not deposited onto the foods. - Page 23 RECOMMENDED COOKING TEMPERATURE Shelf Cooking Food °C °F Mark Position* Time (approx) CAKES Victoria sandwich 2 or 3 20-25 mins Small cakes/buns 1 and 2 15-20 mins Maidera cake 2 or 3 20 mins Fruit cake hours Rich fruit cake 3 or 4 hours Scones...
-
Page 24: Digital Electronic Programmer
DIGITAL ELECTRONIC PROGRAMMER CLOCK AND TIMER WITH “ TOUCH CONTROL” KEYS Keys: Description: Touched simultaneously (for more than 2 seconds): ■ setting the clock; ■ setting the timer vo- lume touching once, along with the “MODE” key); ■ to cancel automatic cooking at any time. -
Page 25: Setting The Clock
“TOUCH-CONTROL” KEYS The “touch-control” keys shall be operated by the fingers (just by touching the key). When using touch controls it is best to use the ball of your finger rather than the tip. The keys are automatically deactivated: ■ 8 seconds after the last selection;... -
Page 26: Automatic Cooking
SETTING THE TIMER VOLUME You can select from three volume levels. ■ Touch the “ ” and “ ” keys simultaneously for more than 2 seconds. ■ Touch the “ ” key; you can read on the display the current timer volume (“ton1”, “ton2”... -
Page 27: Cleaning And Maintenance
CLEANING AND MAINTENANCE GENERAL ADVICE Before you begin cleaning, you must ensure that the appliance is switched off ■ and disconnected from the electrical power supply. ■ It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. - Page 28 INSIDE OF OVEN The oven should always be cleaned after use when it has cooled down. The cavity should be cleaned using a mild detergent solution and warm water. Suitable proprietary chemical cleaners may be used after first consulting with the manufac- turers recommendations and testing a small sample of the oven cavity.
-
Page 29: Replacing The Oven Lights
REPLACING THE OVEN LIGHTS WARNING: Ensure the appliance is switched off before replacing the lamp/s to avoid the possibility of electric shock. ■ Let the oven cavity and the heating elements to cool down. ■ Switch off the electrical supply. LEFT LAMP ■... - Page 30 REMOVING AND REPLACING THE INNER DOOR GLASS PANES FOR CLEANING If you wish to clean the inner panes of glass of the door, make sure you follow the precau- tions and instructions very carefully. Replacing the glass panes and the door incorrectly may result in damage to the appliance and may void your warranty.
-
Page 31: Removing The Oven Door
REMOVING THE OVEN DOOR The oven door can easily be removed as follows: ■ Open the door to the full extent (fig. 20). ■ Open the lever “A” completely on the left and right hinges (fig. 21). ■ Hold the door as shown in fig. 19. ■... - Page 32 CLEANING THE INNER PANES OF GLASS The oven door is fitted with no. 3 panes: ■ no. 1 outside; ■ no. 1 inner; ■ no. 1 in the middle. To clean all panes on both sides it is ne- Figure 24 cessary to remove the inner and the middle panes as follows: REMOVING THE MIDDLE AND...
- Page 33 Remove the middle pane: ■ Gently unlock the middle pane of glass from the bottom clamps by moving it as in fig. 30. ■ Gently lift the bottom edge of the pane (arrow 1 in fig. 31) and remove it by pulling it out from the top clamps (ar- row 2 in fig.
- Page 34 REPLACING THE MIDDLE AND INNER PANES OF GLASS Make sure the door is locked open (see fig. 26). Replace the middle pane: ■ Check that the four rubber pads are in place (“M” in fig. 32). ■ Check that you are holding the pane the correct way.
- Page 35 Replace the inner pane: ■ Check that the four rubber pads are in place (“D” in Fig. 35). ■ Check that you are holding the pane the correct way. You should be able to read the wording on it as it faces you. ■...
-
Page 36: Service And Maintenance
You have set the clock of the electronic programmer (the oven will not work until this has been done). None semi-automatic or automatic cooking program has been selected. Both the fuse and the mains fuse are intact. Should you still require assistance please contact our Customer Service Centre for your nearest Authorised Delonghi Service Agent. - Page 40 .au ww w.de lo nghi.co .nz...