Model:
CH-C1
6. Turn off the main power switch, and then unplug the AC power cord.
7. Remove the SD card containing the NVRAM data from slot #2.
8. Insert another blank SD card into slot #2, plug in the AC power cord, and then turn on
the main power switch.
9. Upload the Address Book Data to the blank SD card with SP5-846-051 (UCS Setting /
Back Up All Addr Book).
Procedure for D135/D136 (Office model) only
If the Fax Option is installed on the machine, do the following:
Print out the "Box Setting List". (User Tools Facsimile Features General
Settings Box Setting: Print List)
Print out the "Program Special Sender List". (User Tools Facsimile Features
Reception Settings Program Special Sender: Print List)
Take note of the settings in "User Tools Facsimile Features Reception
Settings".
Take note of the settings in "User Tools Facsimile Features Send Settings".
10. Turn off the main power switch, and then unplug the AC power cord.
11. Remove the SD card containing the Address Book Data from slot #2.
12. Replace the two NVRAMs on the Controller Board with the new ones.
NOTE:
There are two NVRAMs on the controller board as mentioned in the following section
of the manual: Controller Board
sure to replace the two NVRAMs as a set.
NVRAMs [A] and [B] installed on the Controller Board at the factory are labeled "2M-1"
and "2M-2" respectively. NVRAMs procured as service parts are labeled
"FRAM1/D138E" and "FRAM2/D138E".
T
B
echnical
>
When installing the New Controller Board. Make
ulletin
Date:
8-Oct-13
PAGE: 2/5
No.:
RD135032