Ricoh CH-C1 Technical Bulletin page 222

Model:
Model CH-C1
Note:
- [A] was modified to [B] to ensure that the trailing edge of the paper does not hit the end
fence guide, which can cause the fence to open and prevent the tray from rising. The paper
guide was removed and a metal plate [F] was added. Two spacers were added to correct the
position of the tray set sensor actuator [H] (See "Attaching spacers for parts [B]/[C]"
below).
- [B] was modified to [C] because portion [G] of the metal plate was unnecessary (and was
deleted).
- [C] was modified to [D] to ensure that the actuator [H] can move correctly into the tray set
sensor. To do this, the thickness of the actuator was decreased from 2mm to 1mm. For this
reason, the spacers used for parts [B]/[C] are not needed.
End fence #2 [C]
Cut-in S/N for part [D]:
Model
D135-17 E233CA00209
D135-21 E233CA20001
D135-27 E233CA30006
D135-29 E233CA50001
T
echnical
[H]
Temporary
end fence #2 [C]
2mm
Temporary
S/N
B
ulletin
Date:
fence: D1357510 [D]
Model
D136-17 E243CA00026
D136-21 E243CA20001
D136-27 E243CA30001
D136-29 E243CA50001
No
27-Jan-14 .: RD135068
Permanent end
fence: D1357510 [D]
1mm
Permanent end
S/N
PAGE: 2/3