Adding External Drives To The System - Tascam MMP-16 Owner's Manual

6. Locate the MOC card cage. Note on its cover that the Output board is identified, as well the pot
associated with each channel.
7. Using a plastic tweaker (supplied with the MMP-16), adjust the Output Ch1 pot to +4 dBu, +/-0.025
dB (=-20 dBFS.)
8. Move the audio analyzer input to the next MMP output channel. Repeat step 7. Continue until all 16
channels are calibrated.
End of the analog output level calibration procedure.
Output Converter Board 2 (9-16)
Figure 6-1: Analog Converter cards location within the MMP-16 chassis (top view).

Adding External Drives to the System

Up to five additional SCSI drives can be added to each MMP-16. The drives must be assigned unique
SCSI ID numbers. Two SCSI ID numbers (7 and 0) are already taken by the MMP-16 SCSI controller
card and the removable drive in the internal Kingston carrier of the MMP-16. The external drives should
be added to the system while the MMP-16 is powered down (off).
86 Tascam MMP-16 Owner's Manual • Chapter 6 • Maintenance and Service
Output Converter Board 1 (1-8)
MMP-16