TASCAM MMR-8/MMP-16 Version 4.2 Table of Contents MMR-8 / MMP-16 V 4.2 U ....................3 ERSION PDATE MMR/MMP S ..................3 NSTALLING THE OFTWARE PDATE Downgrade Disk Reminder ........................3 4.2..........................4 HANGES IN ERSION 5.0 P ....................4 OOLS...
MMR-8 and MMP-16. Installing the MMR/MMP Software Update To install software in an MMR-8 or MMP-16, first make sure the unit to be updated already has Version 3.0 or higher software installed (software installed from the two Rescue Disks is also acceptable).
A special Downgrade Disk must be loaded first, using menu 995, followed by installation of the software from the pre – 4.1 release software. See the TASCAM web site for more information and a copy of the special Downgrade software.
MM units. After one unit has completed the boot up sequence, power up the other MM unit. Press mount (stop button) on machines that did not mount volumes. Load desired projects. TASCAM MMR-8/MMP-16 Version 4.2 Owner’s Manual Update...
New Menus (560 and 561) to Enable/Disable Pro Tools Volume and Mute Automation Version 4.2 software for the MMR-8 and MMP-16 adds new menus, 560 Vol Automation and 561 Mute Automation, to enable/disable Pro Tools Volume and Mute Automation. The following rules apply when using automation settings in menus 560 and 561: 1.
Tools session, under specific conditions. Extra 2 Minutes Prior to TapeMode Start Time Eliminated Version 4.2 of MMR/MMP software eliminates the extra 2 minutes of recording time at the beginning of TapeMode projects. TASCAM MMR-8/MMP-16 Version 4.2 Owner’s Manual Update...
Page 8
TASCAM TEAC Professional Division MMR-8/MMP-16 Version 4.2 Update TEAC CORPORATION 3-7-3, Nakacho, Musashino-shi, Tokyo 180, Japan Phone: (0422) 52-5082 TEAC AMERICA, INC. 7733 Telegraph Road, Montebello, California 90640 Phone: (213) 726-0303 TEAC CANADA LTD. 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada Phone: 905-890-8008 Facsimile: 905-890-9888 TEAC MEXICO, S.A.