Local & Studio Monitoring; Headphone Volume (Level); Headphone Jack (Phones) - Tascam MMP-16 Owner's Manual

Local & Studio Monitoring
A front panel headphone jack allows the MMP-16 operator to locally monitor one or more tracks, right at
the front panel, without affecting the output signals. The rear panel mini-jack output on the PRX card is
designed for studio monitoring using a customer-supplied studio monitor amplifier and speaker. The
mini-jack level is not controlled by the front panel volume control, and the audio output of the mini-jack
always presents a mono sum mix of all tracks according to the track monitor selection chosen on the front
panel. Headphone and studio monitoring both follow the Input Monitor selection, so if a track is being
monitored and it is switched to Input Monitor, the audio change will be heard in the headphones and
studio.

Headphone Volume (LEVEL)

The headphone monitoring volume is set by the LEVEL control next to the headphone jack.

Headphone Jack (PHONES)

Even though the Headphone jack is a standard pro-size stereo headphone jack (phone-type), all track
monitoring is done in mono. Either low (8 ohms) or high impedance (600 ohms) headphones can be used.
HEADPHONE NOTE:
To prevent hearing damage, always turn the Headphone Level full off before putting on
the headphones and leave the Level at a low volume until at least one track has been
selected for monitoring.
MMP-16 Tascam MMP-16 Owner's Manual • Chapter 3 • MMP-16 Operation
67