Table of Contents
Advertisement
10
INSTALLATION OF SIDE BURNER
GAS PIPING CONNECTION
(Side burner models only)
1.
Attach the short hose
to the dual outlet
adaptor of the side
burner control valve.
Attach the other end
to the main barbecue
manifold
inlet
tighten with a shifter.
Take care not to over-
tighten.
2.
Attach regulator hose
to outlet of dual outlet
adaptor. Tighten with
shifter, taking care not
to overtighten.
3.
Leak test all connections thoroughly with a soapy
water solution prior to lighting the barbecue.
(Refer page 14 for lighting instructions for side burner).
USE TOOLS TO SECURE CONNECTIONS.
!
TEST FOR LEAKS WITH A SOAP
SOLUTION. Refer page 4.
CONNECTING AND DISCONNECTING
TO GAS SOURCE
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are in
'OFF' position.
NOTE: The 'OFF' position is identified as follows:
a)
Main burner – by a 'dimple' on the stainless steel control
panel.
b)
Side burner – by a black vertical line on the stainless
steel control knob seat.
When the word 'OFF' printed on the control knob, is
aligned with the dimple or black vertical line – the burner is
in the fully off position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information
and safety guidelines located at the front of this booklet.
Check to see that gas cylinder is filled and that the end
of each burner tube is properly located over each
valve orifice. Set burner controls to 'OFF' position.
A
S
and
S
E
M
B
GAS CYLINDER INSTALLATION
!
CONNECTING TO GAS SOURCE
1.
Hang filled gas cylinder
on the cylinder hook.
2.
Attach cylinder connect
device of regulator and
hose assembly to cylinder
valve outlet.
3.
Open the gas cylinder valve
fully to allow gas to flow.
4.
Leak test all connections thoroughly using a
soapy water solution prior to lighting the barbecue.
(Refer to Safety Information at beginning of booklet).
5.
If a leak is found, turn gas cylinder valve off and
do not use barbecue until repairs or replacement
can be made by a local gas supplier.
DISCONNECTING FROM GAS SOURCE
1.
Turn the burner control 'OFF'.
2.
Turn the gas cylinder valve off fully.
3.
Detach the regulator assembly from gas cylinder
valve.
NATURAL GAS INSTALLATION
This barbecue is also certified for use on natural
gas. Contact the supplier for advice in relation to
using your barbecue on natural gas.
If your barbecue is supplied direct from the factory
in a natural gas specification, then it must be installed
by an authorised person.
L
Y
TEST FOR LEAKS WITH A SOAP
SOLUTION, NEVER WITH AN OPEN
FLAME. Refer page 4.
10
Advertisement
Table of Contents
