Installation Planning; Dhc™ Plus Kit Overview; Dhcp-Bk - Napoleon DYNAMIC HEAT CONTROL PLUS Series Installation And Operation Manual

installation planning

EN
The table below lists kit requirements for each installation option. Please read it carefully.
Installation Type
Exterior
Remote Exterior
Remote Inline
1.3 DHC™ Plus kit overview

DHCP-BK

1 x blower housing assembly
1x inline cover assembly
1 x air damper assembly
1 x on/off switch / housing
1 x collar connector assembly
1 x collar plate assembly
2 x mounting bracket
1 x bushing
13 x #9x1/2" screws
7 x #8x1/2" screws
note:
These complete kits always comprise of up to 2 boxes. Please read carefully and ensure to order correct ap-
plication kits for your unique installation.
Though not supplied, armoured cable is required for the wiring of the DHC™ Plus (see "electrical information"
section for more information). Therefore, please ensure you have enough armoured cable on-hand to complete
your unique installation.
1.3.1 DHCP-BK
1
0.141"
Hex
#9-14 Thread, RH
0.348"
Ref.
1
2
3
4
4
W415-1789 / C / 01.29.19
DHCP-BK
Included in each kit:
1 x exterior housing assembly
1 x wall flashing
1 x decorative cover
12 x #9x1/2" screws
Hex
#9-14 Thread, RH
3
2 4
Description
Hardware kit
On/off switch (with housing and nut)
Air damper assembly
Mounting brackets (x2)
DHCP-EK
N/A
DHCP-EK
1 x hot air exhaust assembly
1 x wall flashing
4 x #9x1/2" screws
Hex
2 x #10x1-1/2" screws
#9-14 Thread, RH
5
6 7
Ref. Description
5 Collar plate assembly
6 Collar connector assembly
7 Inline cover assembly
8 Blower housing assembly
9 Bushing
DHCP-HK
N/A
N/A
DHCP-HK
Hex
#9-14 Thread, RH
29/64" 1/8" 1-1/2"
#10 Thread, RH
Quadrex Drive
8 9