Commands And Responses - Smart Technologies SBID-MX265 Installation And Maintenance Manual

CHAPTER C
REMOTELY MANAGING THE DISPLAY
Power state Description
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when
the display is in ON power state.

Commands and responses

To use the room control system to get information about the display or to adjust display settings,
type commands after the command prompt (>), and then wait for the display's response.
CORRECT
>get volume
volume=55
>
If you type a command that the room control system doesn't recognize, you receive an invalid
command response.
The example contains an extra space in the volume command.
INCORRECT
>set vol ume=65
invalid cmd=set vol ume=65
>
NOTES
Use ASCII formatted commands.
l
Commands aren't case-sensitive.
l
You can use the BACKSPACE key when typing commands.
l
Review each entry carefully before you press ENTER.
l
Don't send another command until you receive the response and the next command
l
prompt.
88 smarttech.com/kb/171257