Installing The Display On A Wall; Dealing With Cracked, Chipped Or Shattered Glass; Saving The Original Packaging - Smart Technologies SMART Board MX100 Series Installation And Maintenance Manual

Hide thumbs Also See for SMART Board MX100 Series:

Installation manual (28 pages)

Table of Contents

CHAPTER 2

INSTALLING THE DISPLAY

Dealing with cracked, chipped or shattered glass

The display contains safety-tempered glass. Although this glass is heat-strengthened to help

withstand impacts, the glass can crack, chip or shatter if struck with enough force. (Safety glass is

designed to break into small pieces rather than sharp shards if it is broken.) Temperature changes

can cause a minor crack or chip to become worse, possibly causing the glass to shatter. See the

knowledge base article,

that can cause the display's glass to shatter even when it's not in use.

If the display's glass is cracked or chipped, have it professionally inspected and repaired at a

SMART authorized repair center. If the display's glass shatters, carefully clean up the area and have

the display repaired or replaced.

CAUTION

For safety and to prevent further damage, do not continue to install or use the display if its glass

is cracked, chipped or shattered.

Saving the original packaging

Save the original packaging to repack the display with as much of the original packaging as

possible in case you need to move the display after you initially install it. This packaging was

designed to provide the best possible protection against shock and vibration.

CAUTION

Move the display only in the original packaging or replacement packaging purchased from your

authorized SMART reseller. Moving the display without correct packaging can lead to product

damage and voids the warranty.

NOTE

If the original packaging isn't available, you can purchase the same packaging directly from your

authorized SMART reseller (smarttech.com/where).