Error Messages - Texas Instruments MSP430 User Manual

Programming MSP430 Flash Devices Using the GUI

2.1.4 Error Messages

Table 2-3 shows the error messages that can be displayed in the MSP-GANG430 GUI when an error
occurs during operation.
Error Type
Communication
Setting System
Maintenance
Windows
18
Operation
Table 2-3. Error Messages
ERROR: Unable to read Target!
ERROR: Unable to open COM port − already in use?
ERROR: Unable to close COM port!
ERROR: Synchronization failed. Programmer connected?
ERROR: Time out during operation − Correct COM port selected?
ERROR: Communication − Frame has errors!
ERROR: Select baud rate command not accepted!
WARNING: Target voltage too low for erase / program operation! Set to > 2.7-V.
WARNING: Could not set target voltage − Externally supplied?
ERROR: Value wrong or out of range!
ERROR: Selected file is of unrecognizable format!
ERROR: Selected file is not a firmware update file!
ERROR: Firmware section cannot be erased!
ERROR: Unable to load firmware. Correct file format?
ERROR: Unable to refresh gang programmer system parameters!
ERROR: Unable to load Image buffer! Image buffer erased? Correct file format?
ERROR: Result of operation not received!
FATAL ERROR: Image memory corrupted or erased!
ERROR: Unexpected end of file!
ERROR: File contains invalid record!
ERROR: Wrong target device connected!
ERROR: Image range XXXX−YYYY placed outside of existing memory
ERROR: No target device connected
ERROR: File(s) contains already specified data (code overwritten)
General error!
ERROR: Self test failed – No access to one ore more image buffer devices!
ERROR: Self test failed − No JTAG access to one or more target channels!
ERROR: Self test failed − Target voltage generator (VCCT) does not work properly!
ERROR: Self test failed – System voltage (VCC) not in range!
ERROR: Self test failed − Blow fuse voltage (VPP) not in range!
ERROR: Unable to open file!
ERROR: Error during file I/O!
ERROR: Unable to open INI file!
Copyright © 2003–2010, Texas Instruments Incorporated
Error Message
SLAU101O – March 2003 – Revised May 2010
www.ti.com