www.ti.com
14 Troubleshooting ALP Software
14.1 ALP Does Not Detect The EVM
If the following window opens after starting the ALP software, double check the hardware setup.
It may also be that the USB2ANY driver is not installed. Check the device manager. There should be a
"HID-compliant device" under the "Human Interface Devices" as shown in
The software should start with only "DS90UB954" in the "Devices" pull down menu. If there are more devices
then the software is most likely in demo mode. When the ALP is operating in demo mode there is a "(Demo
Mode)" indication in the lower left of the application status bar as shown in
SNLU223D – AUGUST 2017 – REVISED FEBRUARY 2023
Submit Document Feedback
Figure 14-1. ALP No Devices Error
Figure 14-2. Windows 7, ALP USB2ANY Driver
Copyright © 2023 Texas Instruments Incorporated
Troubleshooting ALP Software
Figure
14-2.
Figure
14-3.
DS90UB954-Q1EVM Deserializer User's Guide
35