Preproduction Checklist; Preproduction Checklist For The Gang Programmer - Texas Instruments MSP430 User Manual

Item No.
1 Is the latest software version installed on the programmer?
2 Are connections between programmer and targets <60 cm long?
3 Is the programmer supplied with 9 to 15 VDC and 300 mA?
4 Are the correct images loaded to the programmer?
5 Are the targets supplied with power by the programmer?
Is the total power consumption of all targets less than 150 mA?
Are pins 7 and 14 of the 25-pin Sub-D connector (or pin 2 on the
14-pin connectors connected to the targets?
6 Or are the targets supplied with power locally?
Is the local supply voltage connected to pin 14 of the 25-pin
Sub-D connector (or pin 4 on the 14-pin connector)?
Is the local supply voltage in the correct range?
SLAU101O – March 2003 – Revised May 2010
Table C-1. Preproduction Checklist for the Gang Programmer
Copyright © 2003–2010, Texas Instruments Incorporated
SLAU101O – March 2003 – Revised May 2010

Preproduction Checklist

Check
Preproduction Checklist
Appendix C
Remarks
81