Troubleshooting Alp Software; Alp Does Not Detect The Evm; Figure 14-1. Alp No Devices Error; Figure 14-2. Windows 7, Alp Usb2Any Driver - Texas Instruments DS90UB954-Q1EVM User Manual

www.ti.com

14 Troubleshooting ALP Software

14.1 ALP Does Not Detect The EVM

If the following window opens after starting the ALP software, double check the hardware setup.
It may also be that the USB2ANY driver is not installed. Check the device manager. There should be a
"HID-compliant device" under the "Human Interface Devices" as shown in
The software should start with only "DS90UB954" in the "Devices" pull down menu. If there are more devices
then the software is most likely in demo mode. When the ALP is operating in demo mode there is a "(Demo
Mode)" indication in the lower left of the application status bar as shown in
SNLU223C – AUGUST 2017 – REVISED NOVEMBER 2022
Submit Document Feedback

Figure 14-1. ALP No Devices Error

Figure 14-2. Windows 7, ALP USB2ANY Driver

Copyright © 2022 Texas Instruments Incorporated
Troubleshooting ALP Software
Figure 14-2.
Figure 14-3.
DS90UB954-Q1EVM Deserializer User's Guide 35