Status Messages - Texas Instruments MSP430 User Manual

www.ti.com

2.1.3 Status Messages

Table 2-2 shows the status messages that can be displayed in the MSP-GANG430 GUI during operation.
Status Type
Progress
System
Setting
Maintenance
SLAU101O – March 2003 – Revised May 2010
Table 2-2. Status Messages
Executing main process...
Erasing image buffer...
Loading image buffer...
Loading checksum of image buffer...
Erasing firmware section...
Loading firmware section...
Initializing firmware...
Changing baud rate...
Executing self test...
Setting signals at target connector...
Operation successful
MSP-GANG430 gang programmer connected.
Result of the operation: See the result section.
COM port settings modified. MSP-GANG430 gang programmer connected.
Target power settings modified
Operation successful
Selftest passed
Copyright © 2003–2010, Texas Instruments Incorporated
Programming MSP430 Flash Devices Using the GUI
Status Message
17
Operation